Re: Prusa Air 2 build

Thanks Ash.
I had finished my build some time ago. But I have been having issues with extruders... I went from a very unreliable wades style extruder to a QU-BD direct extruder which I have had a far bit of issues with but have got it to print at reasonable level. I'm now looking at some small mod's to the Prusa Air 2 design to make it wider and to have no air flow under the print/heat bed.

I will get some pic's, and write up a setup later as I am still tinkering with the firmware..

Cheers,
MATT..