So, I ended up buying the exhaust tailpipe repair paste, from SuperCheapAuto for $8 bucks and it worked quite well. I have already printed around 5 meters of filament with it and so far so good.
It was impossible to apply the paste with gloves, so I did it with bare hands and took extra care to not touch it.
Follow the pictures:
![]()
![]()
[www.flickr.com]
[www.flickr.com]
It was impossible to apply the paste with gloves, so I did it with bare hands and took extra care to not touch it.
Follow the pictures:
[www.flickr.com]
[www.flickr.com]