Greetings Denny,
Mmmm Bulldogs or Manly, not quite sure I hate more....
I had no delusions that the Sharks would win the comp from the spoon holders last year, but note that the Eels have done so in the past.
Reading your previous notes:
Starting from (almost the end), I have put some styofoam under the aluminium bed, after about 15 mins it has reached 97 deg and is very slowly rising.
I have some "Polyair unicell" and will have a chat with a tech at bradfords / csr and get their thoughts on using this as an alternative.
< did that, less than responsive to the application >
The printer is in a very well ventillated area with a current ambient temp of 24 degrees
RE endstop adjustment screw: don't have but I can sure see how advantageous that would be, that being the case, I am considering getting the tip to bed as close as I can, setting the stop in position with some hot glue and then use the spring loaded bed mounting screws to adjust at all extremes (my head is screaming at me that this is a bad idea, but I cannot see that it will not work and in the worse case is reversible).
RE: feeler guages: I have some, just need to find them, could actually be easier and quicker to go to bunnings and buy some more.... the point has been taken.
RE: Calibration, going through the process now
cheers
Daggs
Mmmm Bulldogs or Manly, not quite sure I hate more....
I had no delusions that the Sharks would win the comp from the spoon holders last year, but note that the Eels have done so in the past.
Reading your previous notes:
Starting from (almost the end), I have put some styofoam under the aluminium bed, after about 15 mins it has reached 97 deg and is very slowly rising.
I have some "Polyair unicell" and will have a chat with a tech at bradfords / csr and get their thoughts on using this as an alternative.
< did that, less than responsive to the application >
The printer is in a very well ventillated area with a current ambient temp of 24 degrees
RE endstop adjustment screw: don't have but I can sure see how advantageous that would be, that being the case, I am considering getting the tip to bed as close as I can, setting the stop in position with some hot glue and then use the spring loaded bed mounting screws to adjust at all extremes (my head is screaming at me that this is a bad idea, but I cannot see that it will not work and in the worse case is reversible).
RE: feeler guages: I have some, just need to find them, could actually be easier and quicker to go to bunnings and buy some more.... the point has been taken.
RE: Calibration, going through the process now
cheers
Daggs